ramshot Enforcer in the 5.7?

Reloading info for the 5.7x28mm

Moderator: Grantness

Post Reply
Fotis
Junior Member
Posts: 184
Joined: 11 Dec 2011, 20:45
Location: Cheyenne Wy

ramshot Enforcer in the 5.7?

Post by Fotis » 25 Nov 2019, 18:56

Cartridge : 5.7 x 28 FN
Bullet : .224, 40, Nosler BalTip 39510
Useable Case Capaci: 9.927 grain H2O = 0.645 cm³
Cartridge O.A.L. L6: 1.590 inch = 40.39 mm
Barrel Length : 4.7 inch = 119.4 mm
Powder : Ramshot Enforcer

Predicted data by increasing and decreasing the given charge,
incremented in steps of 1.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !

Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms

-10.0 87 8.10 1653 243 31464 13410 73.8 0.425
-09.0 88 8.19 1674 249 32433 13669 74.5 0.419
-08.0 88 8.28 1696 255 33435 13931 75.2 0.414
-07.0 89 8.37 1717 262 34469 14192 75.9 0.408
-06.0 90 8.46 1739 269 35537 14454 76.6 0.403
-05.0 91 8.55 1761 276 36641 14716 77.3 0.397
-04.0 92 8.64 1784 283 37781 14978 78.0 0.391
-03.0 93 8.73 1806 290 38958 15242 78.7 0.385
-02.0 94 8.82 1829 297 40176 15504 79.4 0.379
-01.0 95 8.91 1851 304 41434 15767 80.1 0.373
+00.0 96 9.00 1874 312 42734 16030 80.8 0.367 ! Near Maximum !
+01.0 97 9.09 1897 320 44079 16292 81.4 0.361 ! Near Maximum !
+02.0 98 9.18 1920 327 45469 16553 82.1 0.356 ! Near Maximum !
+03.0 99 9.27 1943 335 46908 16814 82.8 0.350 ! Near Maximum !
+04.0 100 9.36 1967 344 48396 17073 83.4 0.344 ! Near Maximum !
+05.0 101 9.45 1990 352 49936 17332 84.1 0.339 !DANGEROUS LOAD-DO NOT USE!

Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba 96 9.00 2012 360 51354 17422 89.1 0.335 !DANGEROUS LOAD-DO NOT USE!
Data for burning rate decreased by 10% relative to nominal value:
-Ba 96 9.00 1717 262 34625 14154 70.4 0.404



Anybody tried it? What say you?????

User avatar
panzermk2
Forum Supporter
Posts: 12377
Joined: 19 Aug 2008, 15:51
Location: Pr. CEO Elite Ammunition
Contact:

Re: ramshot Enforcer in the 5.7?

Post by panzermk2 » 26 Nov 2019, 12:37

Source for this?
Jay Wolf
Pr. Elite Ammunition

"Engineers, the oompa-loompas of science!"

Be'ein Tachbulot Yipol Am Veteshua Berov Yoetz
Image

Fotis
Junior Member
Posts: 184
Joined: 11 Dec 2011, 20:45
Location: Cheyenne Wy

Re: ramshot Enforcer in the 5.7?

Post by Fotis » 27 Nov 2019, 10:59

Quick load and an older ramshot powder loading guide

User avatar
panzermk2
Forum Supporter
Posts: 12377
Joined: 19 Aug 2008, 15:51
Location: Pr. CEO Elite Ammunition
Contact:

Re: ramshot Enforcer in the 5.7?

Post by panzermk2 » 29 Nov 2019, 12:18

There some sizable errors starting with case capacity.
Jay Wolf
Pr. Elite Ammunition

"Engineers, the oompa-loompas of science!"

Be'ein Tachbulot Yipol Am Veteshua Berov Yoetz
Image

User avatar
panzermk2
Forum Supporter
Posts: 12377
Joined: 19 Aug 2008, 15:51
Location: Pr. CEO Elite Ammunition
Contact:

Re: ramshot Enforcer in the 5.7?

Post by panzermk2 » 29 Nov 2019, 12:22

Also in all my copies of Ramshot loading guides I have or have seen do not have data for Enforcer and the 5.7. Do you have this manual in hand ?
Jay Wolf
Pr. Elite Ammunition

"Engineers, the oompa-loompas of science!"

Be'ein Tachbulot Yipol Am Veteshua Berov Yoetz
Image

Fotis
Junior Member
Posts: 184
Joined: 11 Dec 2011, 20:45
Location: Cheyenne Wy

Re: ramshot Enforcer in the 5.7?

Post by Fotis » 29 Nov 2019, 19:20

Nope one of the first. Some have inquired about them dropping the data and ramshot said enforcer was not efficient in the 5.7x28mm. Hence my question. What is the usable capacity so I can fix my quickload

Post Reply

Who is online

Users browsing this forum: No registered users and 16 guests