It's a damn close fit. All I needed to do was dremel out the bottom surface of the grip cavity to make it flat instead of angled and it fits perfect. No wobble, no flex. The camera is currently charging, so no pics of the modification needed yet. I'll try to get some up a bit later once it's charged. For now, here's a pic from yesterday at the range with it installed pre-dremel:
You can see it just barely doesn't sit flush in the rear. This is due to the grip cavity having an angled surface on the bottom. After taking out about 1/8" of material and leveling it off it sat flush. Much better ergonomics than the stock grip and gets me one step closer to completing project blackout. :thumb:
Hogue AR grip on the SCAR
-
- Senior Member
- Posts: 2826
- Joined: 17 Mar 2009, 17:34
- custom title: ~( ̄∇ ̄~) (~ ̄∇ ̄)~
- Location: Hotlanta GA
- Contact:
Hogue AR grip on the SCAR
http://www.f00tography.com" onclick="window.open(this.href);return false;
Corporation: n. An ingenious device for obtaining individual profit without individual responsibility.
-Ambrose Bierce
Who is online
Users browsing this forum: No registered users and 13 guests