Page 1 of 1

T6 Quality Control Testing

Posted: 13 Jan 2015, 21:47
by panzermk2
T6 Quality Control Testing

Fired from FsN 5 Feet.

Now as many of you are waiting on the latest run of T6 I thought I would share some testing data with you.

I always test our ammo. Even if it's the same everything from powder to press if one thing changes, operator, day etc samples are taken and tested.

Now we have the latest batch of T6 bullets coming in so I of course tested them to make sure the copper was as a hard as needed.

Now how, you ask, did we test these bullets? Well since it's 15 below I ain't going out side to test and I am sure as hell not going to pop a pork shoulder in my indoor shoot tube and have the wafting smell of shredded rotting pork floating through the shop in a week or so.

So this was the route I went. Bullet went far enough into the sand that it was not recovered.

Image

Image

Image

Image

Image

Image

Re: T6 Quality Control Testing

Posted: 13 Jan 2015, 21:48
by panzermk2
Not so damn tough anymore are you bitch?

Re: T6 Quality Control Testing

Posted: 15 Jan 2015, 08:27
by DistantCorduroy
HAHA nice touch with the laptop. I've flet like doing that more times than I can count.

Re: T6 Quality Control Testing

Posted: 15 Jan 2015, 13:05
by panzermk2
DistantCorduroy wrote:HAHA nice touch with the laptop. I've flet like doing that more times than I can count.
:thumb:

Re: T6 Quality Control Testing

Posted: 28 Jan 2015, 01:33
by JCIS1
I would love 2 or 3 or 4 boxes if I could get it! Is there any hope of that in the near future??

Re: T6 Quality Control Testing

Posted: 10 Mar 2015, 08:53
by Cbus
I'm wanting to order some of this too! I'll try and keep my eye out on when you guys make them!